Xhorse Dolphin XP 005

How to use Xhorse Dolphin XP-005 Key Cutting Machine to decode a VINFAST Fadil key? Following I’m gonna use VVDI Key Tool Max to control the machine as demonstration. Connect to Dolphin XP-005 via Bluetooth. Fix the key to be decoded on clamp firmly. Click  Universal key duplication >> 4 track internal >> Tip align >> M2-A Clamp >> Decode key Dolphin XP-005 machine will start decoding automatically. Just wait it for processing... Universal key decode success. Tap Cutting Preview to check the track on key blank. As you can see, it’s same as the working key. To continue cutting a new key, just replace a blank key on clamp, and click “Cutting key” on bottom. Key decode is quite simple and fast in 2 minutes. For key types that are not in database, we can follow the same way. Dolphin XP-005 plus VVDI Key Tool Max is not a must, but should be much cost-effective.

This post will help you judge if the conductivity of the Dolphin XP005 probe and milling cutter is abnormal. Here are the steps: Step 1. Disassemble the back cover and pay attention to the cover wiring when disassembling. Step 2.  Remove the back cover, you can see these things, take off the wire harness, and remove the Phillips screws (see Figure 1).  Take out the rubber pellets from the front of the device.  There are screws inside.  This strip needs to be removed (Figure 2) Figure 1 Figure 2 Step 3. Use a flat-blade screwdriver to turn the lead screw, align the Z-axis and the outer cover on a horizontal surface (as shown in Figure 3 and Figure 4), remove the Z-axis housing after alignment (as shown in Figure 5), and place the probe next to it.  Remove the screws (as shown in Figure 6).  Remember to be careful when removing it.  There is a conductive wire inside (as shown in Figure 7). Figure 3 Figure 4 Figure 5 Figure 6 Figure 7 Step 4. If the abov...