Xhorse Dolphin XP 005

This article will guide you on how to replace the screen on your Dolphin XP005L machine . 1. Take out the screws to remove the back and handle from the xp005l. 2. Take out those screws and disconnect the cables as shown in the picture, to remove the back from the screen. 3. Use the flat head screwdriver to push out the holder used to fix the screen, to remove the screen from the back case of Dolphin xp005L . 4. Remove the plastic plug from the screen cable with sharp pliers as the picture shows, to remove the whole screen and cable from the xp005l. Tips: Take a picture of that socket before removing it, all pins should be exactly the same position as before when you put it back. Hope it helps you! For more technical services, please follow http://blog.xhorse.co.uk/

Xhorse Dolphin XP005L Key Cutting Machine is able to copy a Citroen VA2T key in minutes successfully. By decoding an original key to cut a new key, this is very simple. Following I'm gonna show how to do. Procedure  Vehicle database >> Citroen >> All key blank >> VA2T Rotate M5 clamp to side B. Put the original key tip align 2nd position. OK >> Decode key Dolphin 2 starts reading the key... Wait until decoding completed. You'll find key bitting have been read out on screen. Remove the original key, and change to a new key blank. Press "Cut key >> Cut". Dolphin 2 will start working again, this time it's cutting key... Turn over the key once cutting side was done. Just repeat same operation to cut the second side. Clean and take out the key when both sides were completed. As you can see, it's same as the original one. It can open the lock. Key cutting is successful! For more Key Cutting Machine tutorials to be updated. http://blog...